You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? TFTP server software must be running on the router. TFTP server software must be running on your laptop. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. The laptop must be on the same subnet as the router's Ethernet interface. The copy flash tftp command must be supplied the IP address of the laptop.
Options: 1, 3 and 4, 2, 4 and 5, 3 and 5 only, 5 only
Options: (A)for better memory utilization use dynamic loading (B) it does not requires special support from the operating system (C) disadvantage is unused routine is never loaded (D) all of the above 27
Which of the following is true when describing a unique local address?
Options: Packets addressed to a unicast address are delivered to a single interface., These are your typical publicly routable addresses, just like a regular publicly routable address in IPv4., These are like private addresses in IPv4 in that they are not meant to be routed., These addresses are meant for nonrouting purposes, but they are almost globally unique so it is unlikely they will have an address overlap.
How should a router that is being used in a Frame Relay network be configured to keep split horizon issues from preventing routing updates?
Options: Configure a separate subinterface for each PVC with a unique DLCI and subnet assigned to the subinterface., Configure each Frame Relay circuit as a point-to-point line to support multicast and broadcast traffic., Configure many subinterfaces in the same subnet., Configure a single subinterface to establish multiple PVC connections to multiple remote router interfaces.
Options: (A)When you use multiplication, division or exponentiation in a formula (B) When you use addition and subtraction in a formula (C) Because Excel uses hidden decimal places in computation (D) When you show the results of formulas with different decimal places than the calculated results 21
Options: (A)Move the selected control to the right (except controls that are part of a layout) (B) Move the selected control to the left (except controls that are part of a layout) (C) Move the selected control up (D) None of these 2